Skip to main content
Skip table of contents

POFC - XX

Esc sequences
This common code allows different esc sequences to be used based on PO dollar amount. This will allow different laser forms based on dollar amount
Code Category: POFC
Code Value: xx (two-character PO format ID)
Short Description: Not required.
Medium Description: Not required.
Long Description: Used for the initial portion of the escape sequence. The "~" is used to represent the escape.
Associated Numeric Values
1: Enter the upper dollar limits. The values should be placed lowest to highest. For example, numeric value (1) contains "5000.00" and numeric value (2) contains "99,999,999.00."
2-5: Same as 1.
Associated Codes
1: Either "L" or "R" for left or right. If blank this is the same as "R." This says whether to print the escape sequence to the left or the right of the data (if any) being printed on line 1.
2-5: Same as 1.
Associated Descriptions
1: Enter the escape sequences related to the numerics. The "~" is used to represent the escape. This will be appended to any escape sequence in the long description. If the PO Total was between 0 and 4,999.99 the sequence in description 1 is used. If the PO Total was 5,000 or greater the sequence in description 2 is used. The escape sequence is printed when line 1 of the PO is printed.
2-5: Reserved for future use.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.