Skip to main content
Skip table of contents

PYFG - PY902C

Recompute Accumulators Flags
Switch settings for Accumulator re-compute process.
Code Category: PYFG
Code Value: PY902C
Short Description: Entering "DEBUG" in this field will cause debug information to be displayed. This is for BusinessPLUS diagnostic use ONLY.
Medium Description: Used to describe the common code.
Long Description: Used to describe the common code.
Associated Numeric Values
1: Entering "1" activates debug mode for Pay Base control.
2: Entering "1" activates debug mode for caching.
3: Entering "1" activates debug mode for detailed debugging.
4: Entering "1" activates debug mode for Pay Base and Hour Base updating.
5: Reserved for future use.
Associated Codes
1-5: Enter the "names" (Code field on the PERIOD DEFINITION screen (PYUPPR)) of special periods that are NOT to be counted in the Num-of-Periods figure on the EMPLOYEE ACCUMULATOR record (PYUPEA).
Associated Descriptions
1: When date ranges are used on CDH assignments, this common code keeps a range-to-date amount in the ITD variable of an accumulator. The default test to see if something should be included in the range is comparing the check date against these assignment dates. If the check date of the last period of the assignment falls after the period end date, this means that the last period where the assignment was active may not be included in the range. If it is desired to consider any period where the assignment was active as part of the range then set Description (1) to "RANGE TO DATE BY PERIOD."
2: Reserved for future use.
3: IGNORE TERM DATE (This wording will inactivate a normal feature when computing employee accumulator records. In the normal operation, employees will be skipped when the Termination Date is before both the Calendar year and Fiscal year begin dates. IGNORE TERM DATE will let those employees be processed.)
4: "PYPACM TRANSFERS OFF" – Causes PY902 to not recomputed accumulators when running PYPACM for records in a transfer period.
5: Enter the USER ID code to allow debug for. For instance, BSITEST will allow DEBUG to show up only for the login BSITEST. All other logins will not see debug even if the short description says DEBUG. Default is BSI if the description is left blank.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.