Skip to main content
Skip table of contents

NUHR - XXXXXXXX

Hours Codes
The following describes each data item on the Common Codes Master screen that applies to the definition of days and hours that a user may be assigned for system log-on. 00:00 to 24:00 is a special code meaning that terminal and password timeouts are never checked. To continue to check terminal and password timeouts, set the NUHR @@ code to 00:00 to 23:59.
Code Category: NUHR
Code Value: XXXXXXXX - Up to eight characters which will be used to qualify a user definition as to days and hours that they may be signed onto the system.
Short Description: Up to eight characters describing the code.
Medium Description: Up to 30 characters describing the code.
Long Description: Up to 72 characters describing the code.
Associated Numeric Values
1-5: Reserved for future use.
Associated Codes
1: Five characters of the form HH:MM which specify the low end of the clock range when a user may be signed on; HH = hours (24-hour clock), MM = minutes (00-59). If the hours code is "00:00" to "24:00," terminal timeout will never occur just because it became midnight. It will still happen if the user leaves it alone too long without doing anything.
2: Five characters of the form HH:MM which specify the high end of the clock range when a user may be signed on; HH = hours (24-hour clock), MM = minutes (00-59).
3-5: Reserved for future use.
Associated Descriptions
1: Up to seven four-character codes which represent the days of the week which a user may be signed onto the system. These codes must be entered in upper case. Associated Codes are as follows: MON TUE WED THU FRI SAT SUN
2-5: Reserved for future use.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.