Skip to main content
Skip table of contents

RXUP - ADHOC

Controls the logic to check for Ledger Codes to make sure that when Ad Hoc reports are run they do not modify data in other ledgers nor allow them to be run outside of the Ledger for which they have been defined.
Note: The Ad Hoc Update screen (RX350) defaults to "ON" to check for Ledger Codes, while the Ad Hoc Report Generator (GL111) defaults to "OFF," so it does not check for Ledger Codes.
Code Category: RXUP
Code Value: ADHOC
Short Description: Not required.
Medium Description: Not required.
Long Description: Not required.
Associated Numeric Values
1-5: Reserved for future use.
Associated Codes
1: OFF
2: ON
3-5: Reserved for future use.
Associated Description
1: Check ledger codes in RX350C.
2: Check ledger codes in GL111C.
3-5: Reserved for future use.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.